Rockford Fosgate P300-12T

Details about the Rockford Fosgate P300-12T

Features

Overview: The Rockford Fosgate Punch P300-12T is an all-in-one bass solution featuring a 12" woofer and a built-in 300 watt RMS amplifier in an enclosure made from 5/8" MDF. Its slim form is designed to easily fit behind seats in pickup trucks, while taking up as little usable space as possible.

Integrated Amplifier: The 12" woofer is powered by a built-in Class-D amplifier rated at 300 watts RMS/600 watts peak. The closed-loop designed ensures optimum performance of the woofer, amplifier, and enclosure system.

Quick Disconnect Power/Ground: The power, ground, and remote turn-on wires attach to a quick disconnect terminal block, so the subwoofer can be easily removed when you need more storage space. Each terminal is a set screw, with the power and ground accepting up to 4 gauge wire (minimum 8 gauge recommended) and the remote turn-on will accept up to 8 gauge wire.

Audio Inputs: The amplifier section will accept either a line level (RCA) or speaker level signal. The included 12" input harness has a Molex plug on one end and female stereo RCA jacks on the other. When using a speaker level input, the RCA jacks get cut off and spliced into the factory wires.

Input Switch: The Input Switch is set based on the incoming signal type:

Low-Level: Used when connecting and RCA level signal into the amp. Range is from 150mV to 6V.
High-Level: Used when connecting the subwoofer using a speaker-level input signal. Range is from 400mV to 12V.
Auto Turn-On: The Auto Turn-On switch offers three options:

REM: the amp turns on when +12 volts DC is applied to the remote terminal
DC Offset: the amp turns on when a 6 volt surge is detected on the signal inputs (from a speaker level source)
Audio: the amp turns on when an incoming audio signal is detected (can be used with line level or speaker level inputs)
Gain Control: The rotary gain control allows you to match the output level of your headunit to the input level of the powered subwoofer.

Crossover: The 12 db/oct low-pass crossover is always engaged; the crossover point is adjustable from 50 to 200 Hz.

Bass Boost: Use the rotary dial to adjust the bass boost; continuously variable from 0 to +12 dB, centered at 45 Hz.

Phase: A switch allows you to reverse the phase of the subwoofer (0°, 180°).

Protection Circuit: The P300-12T is equipped with thermal overload, over voltage, and short circuit protection. The amplifier will shut down if any of these situations is encountered.

Punch Level Control: A wired Punch Level Control is included so you can adjust the output level from the driver's seat. The remote has a bracket to mount it under the dash. The included 16-1/2' cable, with a 3.5mm stereo mini-plug on each end, connects the remote to the subwoofer. Note: The Punch Level Control measures approximately 2-3/8" wide x 1" high x 2" deep (3-1/2" deep including the knob and cable).

Dimensions: The dimensions listed in Features and Specs include the subwoofer's grille, and the power and signal wiring harnesses, which add approximately 1.0" and 1.5" respectively. The depth of just the enclosure is 8.50" at the base and 4.750" inches at the top. The width without wiring is 26.0".